Proteco Q80S, Instruction Manual

Q80S_2014                                                                                                                                                                                                                                                                                      

14

PROTECO S.r.l.

Via Neive, 77 - 12050 Castagnito (CN) ITALY     Tel. +39 0173 210111 - Fax +39 0173 210199      info@proteco.net - www.proteco.net

      AUTOMATIC programming mode, with OBSTACLE DETECTION   

Before starting this programming procedure make sure that the TORQUE/POWER is not set too high: 

in that case please adjust parameter            in             menu to reduce it.

Automatic programming procedure: the control panel 

automatically

 sets motors’ working 

times and force as well as the sensibility level for the obstacle detection (amperometric).

  1  Use                            buttons to move inside the menu, till the display shows:

  2 

Press and hold button 

 for about

 10 seconds. 

The control panel starts the automatic programming procedure, the gate will:

• If open, it start closing till the limit switch bracket meets the motor

• Then it opens till the opening limit position

• Stops and reverses till the fully closed position

• The control unit automatically sets deceleration about 50cm before 

   the fully closed/open position

s

  3 

Now working times, deceleration times and the level of sensibility for obstacle detection 

have been automatically set.

  4  Press button 

to go back to the top level menus, 

then press button 

  again till the display shows:

or wait the timeout (20 seconds) to exit 

  If further adjustments of the sensibility level for obstacle detection are needed, 

please refer to setting             in the              FORCE menu.

4.2 

          PROGRAMMING menu 

Press button            

 and use           

 to select menu             ,

then press button 

 to enter the PROGRAMMING menu: display will show

Use 

 buttons to scroll the lower level menu.

4.2.1 Selecting the PROGRAMMING MODE