Proteco Q80S, Instruction Manual

15 

                                                                                                                                                                                                                                                                                   Q80S_2014

PROTECO S.r.l.

Via Neive, 77 - 12050 Castagnito (CN) ITALY     Tel. +39 0173 210111 - Fax +39 0173 210199      info@proteco.net - www.proteco.net

  If further adjustments of the motors force are needed, please refer to setting          

  in the           FORCE menu

.

Gear motor  default settings

  1 

Use       

 buttons to move inside the menu, till the display shows:

  2  Press and hold button 

 for about 

5 seconds

. 

  3  Press button 

 to go back to the top level menus, 

then press button 

  again till the display shows:

or wait the timeout (20 seconds) to exit.

4.2.2  Restoring DEFAULT SETTINGS 

The control panel comes with pre-set working parameters according to the automation model used.

You can reset the control panel to the default settings as follows:

SEQUENTIAL programming mode

This step-by-step programming procedure allows you full control of each setting and finer professional adjustments

.

The control unit is preset to be programmed by SEQUENTIAL programming mode.

Before starting this programming procedure make sure that the TORQUE/POWER is not set too high: 

in that case please adjust parameter             in            menu to reduce it   

If the control panel is programmed using this procedure, 

obstacle detection

 function 

 is automatically 

disabled

.

  You can program the control panel with the sequential procedure using button            on the control panel 

or using a remote control previously saved.

 1 

Use                            buttons to move inside the menu, till the display shows:

  2  Press button 

to confirm. The display shows:

  3  Press the 

remote control

 (or button 

on the control panel).

• The gate starts closing (if open) and then opens again till the fully open position

  4  When the gate is about to 90% of the opening path, press again the remote control 
 

(or button 

 on the control panel).

• The gate decelerates and continues opening.

  5 

When the gate has reached the fully open position, wait 2-3 seconds and then press 

again the remote control (or button 

) the gate starts closing till the fully closed position

  6  Press button 

 to go back to the top level menus, 

then press button 

  again till the display shows:

or wait the timeout (20 seconds) to exit

.