Proteco Q80S, Instruction Manual

21 

                                                                                                                                                                                                                                                                                   Q80S_2014

PROTECO S.r.l.

Via Neive, 77 - 12050 Castagnito (CN) ITALY     Tel. +39 0173 210111 - Fax +39 0173 210199      info@proteco.net - www.proteco.net

FLASHING LIGHT mode selection

Use these settings to select the signal mode of the falshing light according to the blinker model you have.

  1  Use   

 buttons to move inside the menu, till the display shows:

  2  Press button 

 to confirm 

  3  Use 

 buttons to select:

BLINKING

 signal 

(Standard Flashing Light)

FIX

 signal 

(LED Flashing Light)

  4 

Pre

ss button 

 to go back to the top level menus, 

then press button 

  again till the display shows:

or wait the timeout (20 seconds) to exit.

DEAD MAN’S SWITCH Mode

  Use these settings to control the gate by a 

DEAD MAN’S SWITCH

.  The gate opens/closes only if the button is 

hold pressed, as soon as the button is released the gate stops opening/closing.

  Wirings to the push-buttons have to be separated as follows:

START

 plug 

OPENING

 push-button

PEDESTRIAN START

 plug   

CLOSING

 push buttons

  If this function is enabled any other radio command will be ignored and all safety systems (obstacle detection, 

photocells, sensitive edges,..) are not working.

1  Use   

 buttons to move inside the menu, till the display shows:

  2  Press button 

 to confirm 

  3  Use 

 buttons to select:

STANDARD

 opening/closing mode

DEAD MAN’S SWITCH

 opening/closing mode

4 

Pre

ss button 

 to go back to the top level menus, 

then press button 

  again till the display shows:

or wait the timeout (20 seconds) to exit.