Protector AS-510, Operating Instructions Manual

AS-510

     |  ENGLISH

12

ATTENTION

: When using this device for exhaust air control, 

the shutter must be open to ensure adequate inflow of 
fresh air!

KEY

1  Base receiver
2  Window transmitter with reed contact 
3  Magnet casing for window transmitter (3a,b,c)
U  Packer parts

BASE

 (receiver)

4  LED base window open 
5  LED base window closed
6  LED base network

TRANSMITTER

8  Transmission control LED 
10  Battery compartment cover

MINIMUM OPENING ON WINDOW

This is determined by:
a. The throughput of the air extraction device in m³/h
b. The size of the window to be opened in m²
c. The size of the gap at the window in cm (see Table 1)

Most kitchens are equipped with rectangular combination tilt 
& turn windows.
If the window is, for example, round in form, then ask your 
specialist installation technician or the district flue & chimney 
inspector to calculate the minimum opening.
An example of the required minimum opening for a rectangu-
lar window is shown in the table for tilt/turn adjustment.

Assembly and operating instructions for exhaust 
control model AS-510 (wireless version)

Thank you for purchasing the PROTECTOR wireless exhaust 
control AS-510.

INTRODUCTION

The operating instructions are a constituent part of this 
device. They contain important notes on safety, use and 
disposal. Familiarise yourself with all operating and safety 
notes before using the equipment. Only use the article as 
described and for the listed areas of use. Pass all documents 
to the third party if you transfer the equipment 
to a new owner.

GENERAL

You can use this device as an exhaust air control device, 
as an aid to monitor fresh air supply when commissioning 
an exhaust air device (fume extractor hood, fan etc.).This 
cannot replace self-monitoring to ensure fresh air supply, but 
it can be supportive. This device only activates the exhaust 
air system in the event of pressure equalisation when a 
window or door is opened. The additional fresh air streaming 
in can thus be drawn in from the outside.

This device can also be used to selectively switch devices 
or lamps ON or OFF, for instance when a door or a window 
is closed or opened. This, for example, enables significant 
reduction of energy costs for heating or air-conditioning 
devices.