14.0 Configuration via Protégé®
14.1 Connecting to the Module
Before attempting to connect to the module please ensure that:
• Your system controller has condominium firmware version 7.XX or above.
• It has an ‘Apartment’ profile loaded.
• ‘Controller used for Condominiums’ is checked under the Controller Properties.
• It is online and communicating with the Protégé® Software.
Step 1
Select the
‘Controller’
tab (top level on the screen) and select
‘Condominiums’
(second level
icons).
Step 2
Select the
‘Programming (Condominiums)’
tab from the top of the Condominiums section.
Step 3
Right click on
‘Condominium ##’
where ## corresponds to the address that was set on the module.
Step 4
Select
‘Properties’
from the pop up window.
A pop up box will appear which will show the progress while uploading the current settings from
the controller. If this box does not appear and the Condominium # Properties window appears
immediately then the software is not communicating with the controller.
Step 5
Once the upload is 100% complete click on
‘Close’
and the Properties window will open. The
following sections describe the various tabs of the Condominium # Properties window.
31
