USE AND INSTALLATION MANUAL
*0001117*
0001150 edition: 1/28.05.2020
Page
3
of
5
9.
MARKING
Marking:
a) Name/ type of device.
b) Device model designation.
c) Reference number.
d) Number/year/class of European standard.
e) CE mark.
f) Month and year of manufacture.
g) Serial number of device.
h) Attention: read instruction manual.
i) Marking of manufacturer or distributor of the device.
j) Working Load Limit.
Figure 4 -
Identity label of device with “Next inspection”
sticker
“Next inspection” sticker should be affixed near identity label
and it is necessary to mark month and year of the next
periodic inspection. Do not use the device after this date.
Note:
Before the first use, mark the date of next inspection
(date of first use + 12 months, e.g. first use 01.2013
– mark
01.2014). “Next inspection” sticker affixed near identity label.
Figure 5
– Location of markings
10. INSTALLING RUP507
a) Remove trolley KSB100-350-000 pin.
b) Slide the hoist between trolley platens and again
secure with pin (tighten!).
c) Connect the control to the hoist and lift the cord on
the eye using small snap hook. Tighten nut on the
cable connection.
WCIĄGARKA AKUMULATOROWA RUP-507 - BATTERY-
POWERED HOIST RUP-507
NUMER SERYJNY - SERIAL NUMBER
DATA PRODUKCJI - DATE OF MANUFACTURE
ŁAŃCUCH 4x12-80 - CHAIN 4x12-80
DŁUGOŚĆ - LENGTH
PRĘDKOŚĆ - SPEED
Remote control connector
