Proteus EEC-1500, Owner'S Manual

STEP 1.

 FOLD UP THE HANDLEBAR 

POST ( 17 ) TO THE UPRIGHT 
POSITION, FIX WITH BOLTS 
( 34 / 35 ) AND WASHERS ( 36 ).

STEP 2.

FIX THE BEAM PANEL ( 37 ) 
TO THE MAIN FRAME ( 01 ) 
WITH SCREW ( 39 ). REPEAT 
SAME PROCEDURE ON BEAM 
PANEL ( 38 ).

NOTE: THE PEDAL ARMS ARE NOT FIXED WITH BOLTS. DO NOT HOLD THE PEDAL 
            ARMS FOR MOVING  THE MACHINE.

EEC-1500/1550 ELLIPTICAL ASSEMBLY INSTRUCTION

17 

35 

36 

34 

36 

27 

14 

1 

26

17 

39 

37 

27 

26 

38 

14 

1

- 1 -

STEP 3.

 ATTACH FRONT STABILIZER ( 02 ) & REAR STABILIZER ( 03 ) TO MAIN FRAME ( 01 ), FIX 

WITH CARRIAGE BOLTS ( 40 ), WASHERS ( 42 ) AND NUTS ( 41).

STEP 4.

( FOR EEC-1550 ONLY ) INSERT ADJUST TUBE ( 52 ) TO THE CONNETICTING ARM ( 13,14) 
AND FIX WITH KNOB ( 54 ) AS FIG 1.

STEP 5.

 FIX PEDAL (L)( 10 ) TO PEDAL ARM (L)( 04 ) WITH SCREWS ( 43 ) & WASHERS ( 44 ) 

TIGHTENED FIRMLY. REPEAT SAME PROCEDURE ON THE RIGHT PEDAL THEN 
ASSEMBLE  PEDAL ARM ASSEMBLY LEFT AND RIGHT ( 04 / 05 ) AS FIG. 1 & FIG. 2.

FIG. 2

 INSERT THE SHAFT ( AT REAR SIDE OF PEDAL ARM ) TO THE CRANK JOINT ( 16 ) 

 AT THE MAIN FRAME )

FIG. 3

 THEN INSERT THE OTHER SHAFT (AT FRONT SIDE OF PEDAL ARM) TO THE 

CROSS JOINT ( 15 ) ( AT CONNECTING ARM (L)( 13 ) & ARM (R)( 14 ) )

STEP 6.

 CONNECT PULSE WIRE (A)( 28 ) ( LOCATED ON LOWER END OF HANDLEBARS ) & 

PULSE WIRE (B)( LOCATED ON UPPER END OF CONNECTING ARMS ) THEN INSERT THE 
HANDLEBARS ( 06 / 07 ) TO THE CONNECTING ARMS ( 13 / 14 ) AND FIX WITH BOLTS 
( 46 ), CONICAL BUSHINGS ( 48 ) & NUTS ( 47 ).