OPERATING INFORMATION OF EXERCISE METER
SUMMARY :
THIS SYSTEM IS DESIGNED FOR PROGRAMMABLE MAGNETIC BIKE. THERE ARE 3
PARTS TO THIS SYSTEM, THE MONITOR ( BC-6011II ), MOTOR & CONTROLLER AND
MAGNETIC BRAKING SYSTEM.
GETTING STARTED
1. MONITOR CONNECTIONS :
PLUG THE 10-PIN CONNECTOR (PROTRUDING FROM THE TUBE) INTO THE
RECEPTOR ON THE BACK OF THE MONITOR. SECURE THE MONITOR TO THE
MOUNTING PLATE. BE SURE THAT THE MONITOR CABLE IS NOT PINCHED.
REFER TO YOUR ASSEMBLY GUIDE FOR MORE INFORMATION ON INSTALLING YOUR
MONITOR.
2. POWER UP :
PLUG THE POWER CABLE INTO THE JACK OF THE MOTOR & CONTROLLER.
PLUG THE POWER PACK INTO A WALL OUTLET
AFTER POWER UP, ALL LED LIGHTS WILL LIGHT UP FOR 0.5 SECONDS & CPU WILL
RESET THE RESISTANCE INTO LEVEL 1AND THEN THE SYSTEM GO INTO THE INITIAL
MODE. (THE 8 PROGRAM INDICATION LIGHTS WILL BE FLASHING)
REMARK :
1. IF THE CONNECTION CABLES WERE INSTALLED INCORRECTLY, THE SPEED
FUNCTION WON'T ACTION AND MOTOR WON'T MOVE
2. WHEN STOP EXERCISING, PLEASE REMEMBER TO UNPLUG THE POWER PACK.
BUTTONS AND DEFINITIONS
START/STOP :
A. USE THIS BUTTON TO START OR STOP TRACKING YOUR WORKOUT
B. HOLDING START/STOP FOR 2 SECONDS WILL RESET THE CURRENT PROGRAM &
VALUES, THEN ENTER INITIAL MODE.
SCAN:
USE THIS BUTTON WHILE EXERCISING TO SEQUENTIALLY DISPLAY EACH
FUNCTION(TIME, SPEED, DISTANCE, CALORIE & HEART RATE) FOR 5 SECONDS.
PRESSING THE SCAN BUTTON AGAIN WHILE EXERCISING WILL STOP SCANNING
THROUGH EACH FUNCTION AND WILL DISPLAY THE CURRENT FUNCTION.
- 9 -
