STEP 5. CONNECT EXTENSION CABLE
WIRE ( 8 ) & GRIP PULSE WIRE
( 10 ) TO THE COMPUTER ( 7 )
THEN FIX IT ONTO HANDLEBAR
POST BY USING SCREWS ( 39 ).
NOW THE ASSEMBLY OF THE PROGRAMMABLE ELLIPTICAL IS DONE.
PLEASE NOTE WITH THE FOLLOWING INFORMATION BEFORE USE :
7
8
10
39
2
SILICONE SPRAY WARNING
KEEP OUT OF REACH OF CHILDREN!
IF SWALLOWED OR SPRAYED DIRECTLY ON FACE, SEEK MEDICAL ADVICE.
NOTE: THIS PRODUCT MAY CAUSE DAMAGE OR LOSS IF USED OTHERWISE
THAN STRICTLY IN ACCORDANCE WITH THE DIRECTIONS FOR IT'S
USE.
THIS PRODUCT IS SOLD ONLY SUBJECT TO THESE CONDITIONS AND UPON
THE BASIS THAT IT IS USED SOLELY AT THE PURCHASER'S OWN RISK AND
THE MANUFACTURERS AND DISTRIBUTORS HEREBY EXCLUDE
THEMSELVES FROM ALL LIABILITY IN RELATION TO THIS PRODUCT
HOWSOEVER ARISING.
ELLIPTICAL LUBRICATION INSTRUCTIONS FOR ELLIPTICAL LUBRICATION
WITH SILICON
1. SILICONE SPRAY APPLIED TO THE SLIDE TUBE (12), FOR THE PURPOSE
OF LUBRICATION BETWEEN SLIDE TUBE (12) AND PU WHEEL (32).
2. ALL MACHINE HAS BEEN APPLIED SILICONE WHILE PRODUCTION
PROCESS, THEREFORE, IT'S NOT NECESSARY TO APPLY ANY SILICONE
FOR NEW MACHINE.
3. NOTE TO USE A CLEAN TOWEL TO CLEAN THE SLIDE TUBE AND PU
WHEEL BEFORE LUBRICATION PROCESS
4. IF THERE'S ANY ABNORMAL NOISE / FRICTION NOISE COMES FROM THE
PU WHEEL AND SLIDE TUBE, APPLY LITTLE SILICONE TO THE SLIDE
TUBE, THEN USE THE MACHINE ABOUT 2 MINUTES TO SPREAD THE
LUBRICANT.
5. DO NOT OVER-APPLY THE SILICONE; MAKE IT WITH PROPER
LUBRICATED CONDITION.
6. IF THERE'S STILL ABNORMAL NOISE / FRICTION NOISE COMES OUT,
PLEASE CONTACT YOUR DISTRIBUTOR.
- 6 -
