Monitor will compare your heart rate and target every 30 seconds. If your actual heart rate is 5
b.p.m. below the target, the elevation will increase 1 level. If your actual heart rate is 5 b.p.m. or
more above the target, the elevation will decrease 1 level. If the monitor do not receiver your
heart rate signal, the monitor will display every 30 seconds to remind you and the treadmill
will keep the same elevation level.
If you want to skip the setting function, just simply press ENTER to go to the next preset
function. You do not need to set up all of these functions before exercise. You can just choose
one of them or two of them or all of them.
Note :
a.
Without input your Age and confirm the target heart rate, you cannot proceed with these
two programs.
b. Without the function of TIME, DISTANCE and CALORIE, the monitor will count up the value.
c. Check the wires to the incline motor and see if they are open circuit, disconnected, or the
positive and negative are wrongly connected.
d. Calibrate the Incline function.
e. Check the incline motor to see if it is over-heated and the over-heating protection switch is short
circuit. If so, it will be functioning normal right after the motor is cool down.
40
P
ro
g
ra
m
F
u
n
c
ti
o
n
