Proteus PEC 4950, Owner'S Manual

WARNING :

 BEFORE COMMENCING WITH ANY EXERCISE PROGRAM, PLEASE CONSULT 

YOUR FAMILY PHYSICIAN. IF AT ANY TIME DURING EXERCISE YOU FEEL FAINT, 
DIZZY OR EXPERIENCE PAIN, STOP AND CONSULT YOUR FAMILY PHYSICIAN. IN 
THE EVENT ANY OF THE ABOVE MENTIONED WARNINGS ARE BREACHED BY 
THE CONSUMER, THE MANUFACTURER MAY USE SAME AS A DEFENSE TO ANY 
CLAIM FOR INJURIES, DAMAGE OR LOSS. THE ABOVE WARNINGS ARE IN NO 
WAY INTENDED TO LIMIT OR MODIFY THE CONSUMER'S REMEDIES FOR 
BREACH OF WARRANTIES PURSUANT TO APPLICABLE 

FEDERAL AND STATE 

LAWS OF REGULATIONS

. THEY ARE BEING SUPPLIED STRICTLY TO ENSURE 

THE SAFETY OF THE INDIVIDUALS USING THIS PRODUCT.

BEFORE YOU BEGIN

IMPORTANT:

 READ ALL INSTRUCTIONS CAREFULLY. ASSEMBLE THE UNIT IN ACCORDANCE 

WITH THE STEPS IN THE MANUAL. LAY OUT ALL PARTS ON THE FLOOR AND 
CHECK IF YOU HAVE ALL THE PARTS INCLUDED COMPLETELY BEFORE 
BEGINNING ASSEMBLY. IN CASE OF A DISCREPANCY, PLEASE CALL THE 
CUSTOMER SERVICE DEPARTMENT OF THE STORE FOR HELP. 

NOTE: SOME PARTS MAY BE FACTORY PRE-ASSEMBLED.

TOOLS REQUIRED FOR ASSEMBLY

ONE ADJUSTABLE WRENCH, A PHILIPS HEAD SCREWDRIVER AND A ALLEN KEY

ASSEMBLY

STEP 1.

  ATTACH REAR STABILIZER ( 5 ) TO THE END OF BASE TUBE ( 2 ), FASTEN WITH 

BOLTS ( 3 ) WASHERS ( 4 ). FIT BASE TUBE ( 2 ) TO THE FRAME ( 1 ), FASTEN WITH 
BOLTS ( 3 ), & WASHERS ( 4 )

STEP 2.

FIT FRONT STABILIZER ( 6 ) TO THE FRAME ( 1 ) WITH CARRIAGE BOLTS ( 7 ) & 

WASHERS ( 4 ) & NUTS ( 8 ), NOTE TO PREVENT HEAD OF CARRIAGE BOLTS ( 7 ) 
FROM DAMAGING FLOOR, DIMPLED SQUARE HOLES ON STABILIZER ( 6 ) MUST BE 
FACING DOWN. 

STEP 3.

FIT SEAT PAD ( 20 ) AND BACKREST PAD ( 21 ) TO SEAT TUBE ( 9 ), FASTEN WITH 

SCREWS ( 19 ).

USE SOAP WATER AS LUBRICANT TO SLIDE FOAM GRIP ( 16 ) TO HANDLE BAR ( 18 ), 

FIT END CAPS ( 17 ) ON BOTH ENDS OF HANDLE BAR. ATTACH HANDLE BAR ( 18 ) 
TO SEAT TUBE ( 9 ), FASTEN WITH WASHER ( 4 ) & BOLTS ( 3 ).

STEP 4.

SLIDE SEAT TUBE ( 9 ) TO SLIDE TUBE ( 12 ), THEN ATTACH SLIDE TUBE SET TO 

FRAME WITH BOLTS ( 3 ) AND WASHERS ( 4 ).

THE SAFETY LEVEL OF THE EQUIPMENT CAN BE MAINTAINED ONLY IF IT IS 
EXAMINED REGULARLY FOR DAMAGED AND WEAR.

THE APPLIANCES ARE NOT FOR CHILDREN UNDER 14 YEARS OF AGES.

THE PEDAL CRANK TRAINING EQUIPMENT OF CLASS B AND C IS NOT 
SUITABLE FOR THERAPEUTIC PURPOSES.

REPLACED DEFECTIVE COMPONENTS IMMEDIATELY AND KEEP THE 

EQUIPMENT OUT OF USE UNTIL REPAIR 

.

THE MOST SUSCEPTIBLE TO WEAR PARTS ARE

DRUM MAGNETIC WHEEL
MOTOR
BELT

- 2 -