Protocol DOT VR, Instruction Manual

REMOTE BATTERY AND PHONE INSTALLATION

CHARGING THE DRONE BATTERY

1.  Make sure the drone is turned off.
2.  Remove the battery cover and disconnect the battery from the drone.
3.  Connect the USB charging cable to the battery.
4.  Plug the charger into a USB port. The USB light will turn off while charging  
 

and will turn on once fully charged.

5.  Plug the battery back into the drone and replace the cover. 
 

Charging time: 60 minutes --- Flying time: approximately 6 minutes

CAUTION WHEN CHARGING

1.   When charging, place product on a dry, well-ventilated surface and keep  
 

 away from heat sources. 

2.   Always use adult supervision while charging.
3.   In order to increase battery longevity, avoid repeat charging and excessive  
 

 discharging.

4.   As battery temperature is high immediately after flight, charge after cooling  
 

 down for higher efficiency.

5.   Do not strike or subject battery to hard impacts or sharp surfaces.
6.   Do not use any other charger than that which is supplied with this item.
7.   Do not use or leave battery near a heat source such as fire or space heater;  
 

 exposure to heat may result in reduced performance or in some cases  

 dangerous conditions.

8.   If battery is left in charging state for an extended period of time after being  
 

 fully charged, the battery may automatically discharge.

9.   Never leave the battery unattended during charging.
10.  Do not disassemble battery.
11.  Do not submerge battery in water.

DO NOT CHARGE OVERNIGHT OR BEYOND  
THE CHARGING TIME STATED.  DO NOT LEAVE BATTERY UNATTENDED.

*Battery: Li-Po, 3.7V, 300mAh
If you purchased extra batteries, allow the engines to cool between flights  
in order to prolong engine life.

5