Protocol OCEANA, Instruction Manual

START-UP PROCEDURE

NOTE:
If after 30 seconds, it has not recognized the drone, turn off the controller 
and repeat Start-Up procedure.

Before flying, the drone and transmitter must be turned on in sequence  
and synchronized.  
1.  Place the drone on flat ground.
2.  Press the power button for 2 seconds.
3.  The green lights on the drone are at the front and the red are at the back.
4.  Turn on the remote control.
5.  The indicators on the drone will flash while they are syncing.  
6.  Push the throttle up and then down to sync. The lights will go steady to  
 

indicate the drone has synced.

COMPASS MODE

Users have the option to exit the default orientation (green lights at the front, 
red lights at the back).  In Compass Mode, users can operate the drone without 
orientation.  Regardless of where the drone is pointing, it will turn left or right 
according to the remote’s command.
Compass Mode is good for beginners and is useful for drones that fly too far away 
for the user to be able to tell the orientation.
Follow the below instructions to change to Compass Mode:
1.  It is easiest to set up Compass Mode before flight.  Turn on and sync the  
 

drone and remote.

2.  Make sure your drone is aligned with the remote as indicated in the picture.
3.  Press down on the Compass Mode button for 2 seconds.  The drone’s left  
 

and right LEDs will start to flash.  This indicates that the drone is now in  

Compass Mode.

4.  Press the Compass Mode button again for 2 seconds to leave  
 

Compass Mode.

Front

Rear

Left

Right

Front

Rear

Left

Right

COMPASS MODE

7

6