Now pull the chin strap through the guides on
both sides of the back part of the neck guard (to
do so, it is best to push the neck guard
outwards again).
Push the ‘back snap fastener’ into the socket in
theback under the neck guard on the inside of the
helmet by pushing down hard.
There are two more fasteners at the front of the
chin strap. Snap both of these into the sockets on
both sides (circles). Lock them into place by pulling
slightly, so that they point to the
inside of the helmet.
TIP!
Once you have made finaladjustments to your
chin strap, the excess part of the strap can be cut
off and the cut edge can then be melted using
a lighter.
Make sure the tension of the chin strap is the
same on both sides!
