Too low power setting:
The DNA 30D puts out
a minimum of about 3.2-3.5 volts. With low power
settings (7 to 8 watts) and low resistance atom-
izers (below 2 ohms) the DNA will sometimes be
unable to provide a low enough voltage output to
be power regulating. If this is the case, the Ohms
display will be flashing. The device will still operate.
Device resets:
If the battery is not able to power
the device at the desired setting, or the battery
is excessively discharged, the device may go im-
mediately into a low voltage shutdown. If firing the
device causes the screen to blank out and then
display the welcome screen, you should charge
your battery. This is especially common at power
settings above 20 watts.
Auto power down
The screen will be at full brightness while firing. Af-
ter 15 seconds with no button presses, the screen
will dim. 2 minutes after the last button press, the
screen will fade out and the device will go to sleep
mode. Pressing any button will turn the device and
display back on.
ADDITIONAL INFORMATION
Low-profile 510 Connector
The XPV has a non-adjustable atomizer connec-
tor pin. If the atomizer device does not contact the
connector pin correctly, the XPV will give a “Check
Atomizer” error. Check for liquid pooling in the pin
area, and occasionally wipe the connector clean of
juice and condensation. Most atomizers can screw
flush with the connector but those that have center
pins that extend far below outer threading may bot-
tom out. Do not force the atomizer to screw down,
damage to the connector’s insulator may result.
Maintenance
The XPV requires no regular maintenance. The de-
vice should operate trouble-free through the life of
the battery. Please take care not to allow e-liquid,
water or other foreign substances to enter the
device through the controls, USB port, etc. Casing
can be cleaned with a dry or damp cloth if needed.
Do not use abrasive or caustic cleaning products.
The display screen is protected by a plastic cover.
Clean this cover with a microfiber lens cloth. Blow
off any foreign objects or dust on the surface first,
or scratching could result.
Occasionally, check the tightness of the screws in
the top and bottom of the casing.
Replacing battery
The battery of the XPV is connected with a push
connector. It can be replaced without special tools.
This is intended to only be done when the battery
reaches the end of its life. New batteries with ap-
propriate connectors are available from Protovapor.
Protovapor will install new batteries purchased from
us free of charge (customer covers shipping).
LIMITED WARRANTY
The XPV is covered for a period of 90 days from
purchase against defects in workmanship and
materials. Internal components including the DNA
30D board are covered for a period of 1 year from
purchase.
Repairs
Repairs on all components of the XPV are available
from Protovapor.
SPECIFICATIONS
Output wattage:
7-30 watts
Output voltage:
3.2* to 8.3 volts
Output current:
6 amps max
Atomizer resistance:
0.3** to 3.3 ohms
Efficiency:
94%
* Approximate, and varies with battery charge state. Approx.
3.5v fully charged.
** Approximate
PROTOVAPOR
XPV
