User Manual
Cable Cross »
CC230P
WARNING! Before carrying out any operations with the unit, carefully read this instruction manual and keep it with cure for future
reference. It contains important information about the installation, usage and maintenance of the unit.
In order to improve the quality of products, Music&Lights S.r.l. reserves the right to modify the characteristics stated in this instruction manual at any time and without prior notice.
All revisions and updates are available in the ‘manuals’ section on site www.musiclights.it
For further information, please contact our Service Center: tel. +39 0771 72190 fax +39 0771 721955 - service@musiclights.it
Rev.01 - 09/15 ©2015 Music & Lights S.r.l. - Italy - www.musiclights.it
EN
Description
Heavy-duty and lightweight crossover cable with 2 channels for the crossing up to 30mm of section.
• Base: module built in resistant and lightweight thermoplastic polyurethane
• Closing panel: yellow anti-slip polyethylene
• Hinge joint designed to set and remove quickly the lids
• Side ramps with mild slope also for the crossing for small wheels, as strollers and wheelchairs
• Base surface realized to obtain a maximum ground grip
• Modulation with dovetail joint system for a simplified installation and fast fixing
• 2 channels for the positioning of cable up to 30 mm section
• Practicals lanes for the sorting of each channel
•
Fire resistant properties, electrical isolation and resistant to acid and solvents
Assembly and installation
1.
Assemble sections by aligning
male connectors over
female connectors (fig.1).
2.
Use foot to work female connectors down around male connectors.
3. Open lid and lay cables into channels. Close lid flush with base.
4.
Verify installation and inspect periodically.
NOTE - Generally, lines are stable enough to be walked on or driven over without any additional precautions. If
the is subject to higher demands occasionally, so that there is a risk of the line shifting during use, we recom
-
mend additionally anchoring the line to the ground or floor.
Module dimensions
CC230P
Length
1000 mm
Width
250 mm
Height
45 mm
Channel Width
30 mm
Channel Height
30 mm
Weight
4,5 kg
Load
3000 kg
General instruction
• Cablecross is a cable protection system intended to reduce the possibility of damage to cables and hoses that are subject to vehicular or pedestrian
traffic. It is intended for temporary installations only and must be in accordance with all applicable safety codes. • Each user is responsible for the manner
of installation and selection of cables to be protected with the help of the cable cross.
Warnings and installation precautions
• Misuse of this product can cause electrical shock and injury. • Do not use connectors or splices whitin the product installed. • Do not use as a work
surface: do not cut, do not drill, do not hammer. • Inspect area for safety hazards. • Use only on a stable level surface. Inclined surfaces, slippery surfaces,
and broken ground can cause injury. • This product can be a trip hazard to pedestrian traffic if they are unaware of its presence. Keep the product clean
and bright. Please note that additional markings / hazard warnings or even permits may be required when using cable cross on public thoroughfares,
walkways, etc. • Test before use and inspect periodically. • Keep the various services, communications, fluids, and some power separated. Limit each
channel to one service type. • Vehicular traffic must pass over the product slowly and with caution. • Do not stand on the cable cross with weights, pass
only momentary loads. • Do not stack ladders or any type of structure. • Avoid concentrated loads.
Fig.1
