iSCSI GbE to SAS/SATA II RAID Subsystem
User Manual
29
3.3 Disk Drive Installation
This section describes the physical locations of the hard drives supported by the
subsystem and give instructions on installing a hard drive. The subsystem supports
hot-swapping allowing you to install or replace a hard drive while the subsystem is
running.
3.3.1 Installing a SAS Disk Drive in a Disk Tray
1.
Unlock the Disk Trays using a flat-head screw driver by rotating the Lock Groove.
2.
Press the Tray Open button and the Disk Tray handle will flip open.
3.
Pull out an empty disk tray.
Tray
Open
Button
Summary of Contents for 3164S1/D1-G1S3
