iSCSI GbE to SAS/SATA II RAID Subsystem
46
User Manual
Step 2: Please select the combination of the RG capacity, or “Use default algorithm”
for maximum RG capacity. After RG size is chosen, click “Next”.
Step 3: Decide VD size. User can enter a number less or equal to the default number.
Then click “Next”.
Step 4: Confirmation page. Click “Finish” if all setups are correct. Then a VD will be
created.
Step 5: Done. The system is available now.
NOTE: A virtual disk of RAID 0 is created and is named by system
itself.
Summary of Contents for 3164S1/D1-G1S3
