iSCSI GbE to SAS/SATA II RAID Subsystem
User Manual
53
5.2.5 Notification Setting
“Notification setting” can be used to set up SNMP trap for alerting via SNMP, pop-up
message via Windows messenger (not MSN), alert via syslog protocol, and event log
filter.
“SNMP” allows up to 3 SNMP trap addresses. Default community name is set as
“public”. User can choose the event log levels and default setting only enables INFO
event log in SNMP. There are many SNMP tools. The following web sites are for your
reference:
SNMPc:
http://www.snmpc.com/
Net-SNMP:
http://net-snmp.sourceforge.net/
Using “Messenger”, user must enable the service “Messenger” in Windows (Start
Control Panel
Administrative Tools
Services
Messenger), and then event logs
can be received. It allows up to 3 messenger addresses. User can choose the event log
levels and default setting enables the WARNING and ERROR event logs.
Using “System log server”, user can choose the facility and the event log level. The
default port of syslog is 514. The default setting enables event level: INFO, WARNING
and ERROR event logs.
Summary of Contents for 3164S1/D1-G1S3
