iSCSI GbE to SAS/SATA II RAID Subsystem
56
User Manual
IP settings:
User can change IP address by moving the mouse to the gray button of LAN port, click
“IP settings for iSCSI ports”. There are 2 selections, DHCP (Get IP address from
DHCP server) or static IP.
Default gateway:
Default gateway can be changed by moving the mouse to the gray button of LAN port,
click “Become default gateway”. There is only one default gateway.
MTU / Jumbo frame:
MTU (Maximum Transmission Unit) size can be enabled by moving mouse to the gray
button of LAN port, click “Enable jumbo frame”.
WARNING! The MTU size of network switch and HBA on host must
be enabled. Otherwise, the LAN connection will not work properly.
Multi-homed / Trunking / LACP:
The following is the description of multi-homed/trunking/LACP.
1.
Multi-homed: Default mode. Each of iSCSI data port is connected by itself and is
not set to link aggregation and trunking. Selecting this mode can also remove the
setting of Trunking/LACP at the same time.
Summary of Contents for 3164S1/D1-G1S3
