iSCSI GbE to SAS/SATA II RAID Subsystem
User Manual
79
5.4.6 Example
The following is an example for creating volumes. Example 1 is to create two VDs and
set a global spare disk.
Example 1
Example 1 is to create two VDs in one RG, each VD uses global cache volume. Global
cache volume is created after system boots up automatically. So, no action is needed
to set CV. Then set a global spare disk. Eventually, delete all of them.
Step 1: Create RG (RAID group).
To create the RAID group, please follow these steps:
1.
Select “/ Volume configuration / RAID group”.
2.
Click “Create”.
3.
Input an RG Name, choose a RAID level from the list, click “Select PD” to
choose the RAID PD slot(s), then click “OK”.
4.
Check the outcome. Click “OK” if all setups are correct.
Summary of Contents for 3164S1/D1-G1S3
