9
1. Ratchet Switch - This switch has 3 positions. The highest
position is to pull. The lowest position is to release. The midd-
le position is for both pull and release, but can only be used
when you are no load. When the winch is loaded, hold the
handle firmly if you want to change the switch position.
2. Before use, install the winch on a firm, flat surface. To install,
turn the ratchet switch in the middle position and pull the
cable out until the final hole of the base are visible. Then use
at least 3 sets of bolts and nuts 3/8 “in a triangular pattern to
secure the base to the surface. If necessary, use an extra sheet
of metal or hardwood.
3. Then install the crank shaft with screw and nut.
4. Place the ratchet switch in the highest position and turn
the crank clockwise to pull a watch. Put the switch pawl in the
lower position and turn the crank in the opposite direction to
a clockwise to loosen.
3. PRECAUTIONS OPERATION WINCHE
Precautions
Winch operation
Summary of Contents for PWUT Series
