Version 1.0
9
Operation
9
1
2
3
4
1
2
3
4
Wire Rope:
The class of wire rope used is 6x19, wire core and galvanized, including 6x21, 6x25 and 6x26.
The wire rope used by our factory is 6x25. The end to be inserted into the unit should be tapered and
burned for easy use.
This unit comes with extra shear pins located in the
handle. To release the jaws, hold reversing lever (2)
and release lever (3) together with one hand, pull
lever (1) forward slightly at the same time pushing
(2) and (3) forward until release lever (3) slips into
notched position in casing. Insert the tapered end
of the wire rope into the rope entry (4) and push
through until it extends through the outlet. The
wire rope end may have to be pushed up or down
slightly to clear the hook or fitting at forward end.
Pull the wire rope through by hand to take up the
slack to the load and ensure that the exit is not
obstructed. Push the release lever (3) down, it will
spring back into original position. The jaws are now
closed on the wire rope. Place the telescopic han-
dle on either (1) or (2) depending upon whether
forward or reverse action is required, and crank the
operating lever forward and backward evenly.
Return the release lever to “release” position when
not in use.
