Notice how parts are placed in the picture. Fit the short hinge pins onto the ends of the Susp. Arms
and attach the e-clips; these will be used later.
4.2: Open bag 6 and find the Front Shock Tower -60007-, which is most distinct from the Rear Shock
Tower by its Body Post Mounts being smaller. Place the long white bushings from the same bag as
the plastic clips in the corresponding holes of the Shock Tower, making sure holes are pointing down,
and then mount it on the front Gear Box as shown, making sure the Hinge Pins of the Upper Susp.
Arm register in the holes of the white bushings.
4.3: Take the Front Top Plate -60009- from bag 6, remove the screws lightly fastened to the Steering
Saver posts and Front Brace, and then fasten the Front Top Plate to the Assembly with those same
screws, facing as shown in pictures, and use the Self-tapping Screws 3*10 in the small bag for the two
remaining holes. Then fix the Radio Tray -61003- on top of the Servo using the Self-tapping Screws
4.4: Place the long Hinge Pins remaning from bag 5 into the
holes of the Lower Susp. Holder, and then slide on the Front
Lower Susp. Arms -60005-. It is very important to notice how
this part is mounted, and note the small Grub Screw in the
part that should be facing up! Take the Front Lower Susp.
Arm Holder -60013- from bag 19 that was set aside in step
1.0, place two of the short white bushings in it with holes
pointing down, and mount it on the front as shown, with
hinge pins registering in the holes of the white bushing.
4.5: Open bag 18 and find the small bag containing screws.
Retrieve the 2 Countersunk Self-tapping Screws 3*40 -
60084- from the bag and use them to fix the Susp. Arm
Holder from step 4.4 to the Gear Box.
