5.0: Rear Suspension Assembly
Youtube guide for this stage:
Requires following bags:
4:
60006 Rear Lower Susp. Arm
60034 Rear Upper Susp. Arm
60043 E-Clips Ø2.5
60067 Rear Hub Carrier Hinge Pins 3*19.7
60072R Rear Lower Susp. Arm Hinge Pin 3.5*64
All remaining parts from bags 6, 15, 16, 18 opened in previous steps.
5.1: Start by placing the short white plastic bushings in the
Rear Lower Susp. Holder, ensuring holes face down as
previously when placing these. Then push the long Hinge
Pins -60072R- from bag 4 through the Rear Lower Susp.
Arm -60006- from the same bag, and insert one end into
the bushings just mounted. Notice facing of the part in
relation to other; take particular care that the grub screw
must face upwards!
5.2: Now place the Rear Lower Susp. Arm Holder -60019-
on the Rear Assembly. Notice it will register in a cutout on
the Chassis plate, as well as the Hinge Pins of the Susp.
Arms. For this, ensure holes of the long white bushings
are facing out to each side. Then fix the Rear Bumper -
62049- from bag 18 onto the model using Cap Head Self-
tapping Screw 3*42 -60123- from the same bag. Using the
remaining 2 Self-tapping Screws 3*16 from bag 9, securely
fix the Rear Assembly to the Chassis from bellow.
5.3: Now mount the Rear Sway Bar from bag 16 in the
same manner as from step 4.7, by using the Mech Screws
3*16 and the small plastic Fasteners and screws from the
same bag. For the fasteners, the screw goes in the lower
of the two holes.
