7.0: Rear Hub Carrier
Youtube guide for this stage:
Requires following bags:
17:
60012 Rear Hub Carrier
60093 Wheel Axle
85711 Wheel Hex + Nuts
85763 Bearings
85834 Set Screws 5*4
60096 Rear Dogbones from bag 11 opened in step 3.2.
7.1: As in the previous assembly, start by pushing into place the Ball
Bearings 16*8*5 -85763- on each side of the parts, making sure they
are level in relation to the part before force is applied. Push the Wheel
Axle -60093- though the bearings and rotate to ensure parts are fitted
correctly.
7.2: Place the Wheel Hex -85711- on the end of the Wheel Axle, line up
holes of both parts and push the steel pin through. As with the
previous assembly in step 6.2 some force may be required, but take
care to not damage any parts in the assembly. Rotate parts to ensure a
correct secure fit and low friction movement, use washers if needed.
7.3: To secure the part to the model, first remove the Hinge Pin from
the Rear Lower Susp. Arm, similar to in step 6.4, by removing the
locking screws and pushing the pin out. Place the Hub Carrier Assembly
correctly, and then replace the pin and fasten screw, as shown in
picture. Now position the Rear Dogbone -60096-, making sure it
registers in Drive Cups of both the Rear Differential and the Rear Hub
Carrier. Finally, remove the Hinge Pin from the Rear Upper Susp. Arm by removing an e-clip, lower
the arm into place and then replace the Hinge Pin and e-clip.
