2.6: Open bag 20 containing the Servo, and start by
fixing the Servo Mounts to the Servo itself using the
short cap-head Mech Screws, as shown in picture.
Notice how parts are facing in relation to each other.
2.7: Fasten the Servo to the Chassis just behind the
Steering Saver. There are 4 holes, 2 for register pins
and 2 for screws. For this, use the Countersunk Self-
tapping Screws 3*10 from bag 9, the one the Chassis
was in. Then push the open end of the Servo Arm onto the shockball on the Steering Saver, and
finally fasten to the servo with the small Mech Screw remaining, as shown in picture.
If you are having difficulty mounting the servo properly, consider removing the sideguard for easier
access to the screws of the servo mount. When doing this, you will need to leave the screws securing
the servo to the chassis slightly lose so there is room for the sideguard to fit under the edge of the
servo.
Finally, screw the two remaining Cap Head Mech Screws lightly onto the top of the Steering Saver
Posts for later, as shown in picture.
