3.0: Center Diff. and Braces
Youtube guide for this stage:
Requires following bags:
10:
60032 Front Brace
60033 Rear Brace
60075 Column Head Mech Screw 3*30
60078 Cap Head Self-tapping Screw 3*10
61015 Rear Brace Mount
85793 Nylon Nuts M3
11:
60031 Front Universal Drive Joint
60063 Center Front Dogbone
60064 Center Rear Dogbone
60096 Rear Dogbone
12:
60048 Center Diff. Mount
60054 Center Diff. Top Plate
60079 Cap Head Self-tapping Screw 3*12
61016 Antenna Mount
14:
61004 Battery Cover
61006 Battery Case
3.1: Open bag 10 and mount both Braces to the
Chassis using Self-tapping Screw 3*10 from bag 9.
Close to the middle of the Chassis you will see a
rectangular hole with 3 holes each side, and then two
holes in a row beyond those. These are the mounting
points for the Braces. The Brace with the pivoting
piece on top is the Rear Brace, the other one is the
Front Brace. Mount as shown in picture.
3.2: Retrieve from bag 11 the Center Front Dogbone and Center Rear Dogbone; these are the two
Dogbones of unique length –the longest and the shortest one, where the other 4 Dogbones are in
identical pairs. Have the remaining Dogbones stay in its bag for now! Also open bag 12, and get the
Center Differential you set aside from bag 7 in step 1.1.
