Chapter 3 Software Utilities
PA-5822 USER MANUAL
Page: 3-56
3.4.3
Configuring WatchDog Timer
The I/O port address of the watchdog timer is 2E (hex) and 2F (hex). 2E (hex) is the
address port. 2F (hex) is the data port. User must first assign the address of register by
writing address value into address port 2E (hex), then write/read data to/from the
assigned register through data port 2F (hex).
Configuration Sequence
To program F81866 configuration registers, the following configuration sequence
must be followed:
(1) Enter the Extended Function Mode
To place the chip into the Extended Function Mode, two successive writes of 0x87
must be applied to Extended Function Enable Registers (EFERs, i.e. 2Eh or 4Eh).
(2) Configure the Configuration Registers
The chip selects the Logical Device and activates the desired Logical Devices
through Extended Function Index Register (EFIR) and Extended Function Data
Register (EFDR). The EFIR is located at the same address as the EFER, and the
EFDR is located at address (EFIR+1). First, write the Logical Device Number (i.e.
0x07) to the EFIR and then write the number of the desired Logical Device to the
EFDR. If accessing the Chip (Global) Control Registers, this step is not required.
Secondly, write the address of the desired configuration register within the Logical
Device to the EFIR and then write (or read) the desired configuration register
through the EFDR.
(3) Exit the Extended Function Mode
To exit the Extended Function Mode, writing 0xAA to the EFER is required. Once
the chip exits the Extended Function Mode, it is in the normal running mode and
is ready to enter the configuration mode.
Code Example for Watchdog Timer
Enable the watchdog timer and set the timeout interval to 30 seconds.
; ------------------------- Enter to extended function mode
mov
dx,
2eh
mov
al,
87h
out
dx,
al
out
dx,
al
; ----------------------- Select Logical Device 7 of watchdog timer
Summary of Contents for PA-5822 M1
Page 10: ...vii Figure 3 26 Boot Menu Screen 3 52 Figure 3 27 Save Exit Menu Screen 3 54...
Page 32: ...Chapter 2 Hardware Configuration PA 5822 USER MANUAL Page 2 11 Jumper Diagrams Jumper Settings...
Page 119: ...Appendix A System Diagrams PA 5822 SERIES USER MANUAL Page A 2 HDD Tray Disassembly...
Page 120: ...Appendix A System Diagrams PA 5822 SERIES USER MANUAL Page A 3 MSR module Assembly...
