xvii
Proxess C-Series Service Manual
STEP 1
STEP 4
Install the latch in the door. The latch tube prongs should
project into the chassis hole.
To re-hand the lock chassis, begin by first removing the rubber
gasket from the back of the lock, and removing the FFC cable
from the cable slot.
Unscrew the backplate to remove the lock chassis and turn it
180 degrees to accommodate the hand of the door.
Replace the lock chassis and reroute the FFC cable into the cable
slot. Screw on the backplate and replace the rubber gasket.
STEP 2
Install the strike plate, checking to make sure that the position
of the deadlocking plunger is aligned against the strike plate.
STEP 3
Ensure the cable from the exterior board is properly routed
through the cylindrical lock chassis by first inserting one edge,
then pressing the other into the cable slot.
1
2
3
4
5
Rotate 180 degrees
Re-handed lock chassis to
accommodate left handed door
Summary of Contents for PX10100001
Page 1: ...C Series Service manual...
