xix
Proxess C-Series Service Manual
STEP 8
STEP 10
Slide the rubber gasket over the chassis sleeve
.
Place the motor wire on top of the handle assembly when
installing the interior trim onto the back plate. Also ensure that
the 10-pin FFC and 4-pin handle switch connectors run along the
sides of the interior trim. Screw the interior trim onto the back
plate using the two screws on the right and left of the battery
hole.
STEP 9
Connect the motor connector first, followed by the latch
connector. Then connect the 4-pin handle switch connector.
Connect the FFC cable last.
Note: The battery cable should already be pre-connected
.
STEP 11
Install the four AA batteries, beginning with the outer two.
After the batteries are properly installed, the lock should beep
once and the motor should run. The lock is then locked.
Handle switch
connector
FFC connector
Battery connector
Motor connector
Latch connector
1
2
3
4
Motor wire should
run along here.
Both the FFC and hand switch connectors
should run along the sides of the trim.
Insert first
Insert last
Summary of Contents for PX10100001
Page 1: ...C Series Service manual...
