xxii
Proxess C-Series Service Manual
C. FRAME PREPARATION
1. Close the door and mark the horizontal line aligned to the strike.
2. Measure one half of door thickness from door stop to mark vertical center line of strike. Drill Ø1" (25 mm) hole, 1/2" (12.7
mm) deep at intersection of horizontal and vertical center lines.
3. Chisel out the jamb 3/32" (2.4mm) deep or until strike is flushed with jamb and then secure the strike to the jamb using two
#12-
24 x 1” screws (SB3).
Note that if you have an interior door that does not require a Grade 1 lock, the door does not need to be drilled out to accommodate
the through bolt posts. Instead, you can change the lock to Grade 2 by simply removing the through bolt posts from the lock chassis
and continuing with the installation.
After removing the screw
posts, reassemble the lock
chassis and reroute the FFC
cable through the cable slot.
Then screw back on the
backplate and replace the
rubber gasket.
1
Through bolt posts
Remove the rubber gasket
2
Remove the FFC
connector from the cable
slot
3
Unscrew the
backplate screws
Remove the
backplate
5
4
Pull out the lock chassis
6
7
Slide out the
through bolt
posts
Summary of Contents for PX10100001
Page 1: ...C Series Service manual...
