Configuration
MP.11 4954-R Installation and Management
Filtering Parameters
91
• To block traffic between a specific wired MAC address and a specific wireless MAC address, configure all four
parameters.
See
Static MAC Filter Examples
for more detailed examples.
Add Entries to the Static MAC Filter Table
To add the entries to Filter table, click the
Add Table Entries
button.
After entering the data, click the
Add
button. The entry is enabled automatically when saved.
To edit an entry, click
Edit
. To disable or remove an entry, click
Edit
and change the
Status
field from
Enable
to
Disable
or
Delete
.
The following fields are may be configured or viewed:
•
Wired MAC Address:
Enter the MAC address of the device on the Ethernet network that you want to prevent from
communicating with a device on the wireless network.
•
Wired Mask:
Enter the appropriate bit mask to specify the range of MAC addresses to which this filter is to apply. To
specify only the single MAC address you entered in the Wired MAC Address field, enter 00:00:00:00:00:00 (all
zeroes).
•
Wireless MAC Address:
Enter the MAC address of the wireless device on the wireless interface that you want to
prevent from communicating with a device on the wired network.
•
Wireless Mask:
Enter the appropriate bit mask to specify the range of MAC addresses to which this filter is to apply.
To specify only the single MAC address you entered in the Wireless MAC Address field, enter 00:00:00:00:00:00 (all
zeroes).
•
Comment:
Enter related information.
•
Status:
The Status field can show
Enable
,
Disable
, or
Delete
.
