Page 16
Copyright © 2006 Proxim Wireless
step 5: View leds
On most units, the LEDs are present at the unit’s Ethernet connector; unscrew
the watertight cap if necessary to view the LEDs.
NOTE:.
Make sure the domed sealing nut is loose before unscrewing the cap or the
Ethernet cable may be twisted and damaged.
When the unit is powered on, it performs startup diagnostics. When startup is
complete, the LEDs show the unit’s operational state, as follows:
LED.State
Power/Ethernet.LED
Radio.LED
Blinking Green
Power is on, unit is booting up,
Ethernet link is down.
Radios are being initialized.
Steady Green
Power is on, Ethernet link is up.
Radios are being operational.
Note:
On FC units, there is one LED. It is the power LED that appears in the back
of the unit, between the cooling fins on the right side. (
See Figure 2
.)
On power-up, the LED flashes red during initial start-up, and then turns
solid red while booting. After a successful boot, it becomes solid green to
indicate normal operation.
Caution!
Before.applying.power.to.the.units,.make.sure.that.a.proper.load.or.
antenna.is.connected.to.each.N-female.jack.to.minimize.the.chance.
of damaging the internal RF power amplifiers.
