Monitoring
QB.11-R Installation and Management
Temperature
135
Temperature
The feature for reporting and logging internal unit temperature observes and reports the internal temperature of the unit.
Temperature is logged and an SNMP trap sent when the internal temperature crosses the limit of 0ºC to 55ºC (at 5
degrees before the limit, the unit issues a warning trap).
You can select a recording interval from one to sixty minutes, in 5-minute increments on the
Configure > System
tab. A
log file holds the recorded data. The log can hold at least 576 entries (two days with the refresh time of 5 minutes). For
further analysis, the log can be exported to a text file with a new line feed as a line separator.
The Temperature Log contains two sub-tabs: Current Temperature and Log.
Current Temperature
The
Current Temperature
tab indicates the unit’s current temperature. The current temperature value is refreshed every
4 seconds.
Log
The
Log
tab keeps track of the temperature recorded at the end of each configured logging interval. You can reset or
refresh the log using the
Reset
and
Refresh
buttons.
