Procedures
QB.11-R Installation and Management
Soft Reset to Factory Default
147
Soft Reset to Factory Default
If necessary, you can reset the unit to the factory default settings. Resetting to default settings means that you must
configure the unit anew.
To reset to factory default settings using the Web Interface:
1. Click the
Commands
button and the
Reset
tab.
2. Click the
Reset to Factory Default
button.
The device configuration parameter values are reset to their factory default values.
If you do not have access to the unit, you can use the procedure described in “Hard Reset to Factory Default” below
as
an alternative.
NOTE:
Each QuickBridge.11 pair (BSU/SU) is configured with an encryption key (randomly generated) during
production. For the QuickBridge to work after “reset to factory default”, you must re-configure the encryption key
for the BSU and the SU to be the same.
