QB.11-R Installation and Management
48
4
Basic Management
This chapter describes how to configure and monitor the unit’s basic features. In most cases, configuring these basic
features is sufficient. A full overview of the Web Interface is provided in “Chapter 5. Using the Web Interface”. The
“Glossary” in
Tsunami MP.11/QB.11 Reference Manual
provides a brief explanation of the terms used. For CLI
commands you can use for basic management, see “Command Line Interface“in
Tsunami MP.11/QB.11 Reference
Manual
. The following topics are discussed in this chapter:
•
•
•
General Configuration Settings
•
•
•
•
Navigation
To use the Web Interface for configuration and management, you must access the unit. With ScanTool you can
determine the unit’s current IP address. Then enter
http://<ip address>
in your Web browser (for example
http://
10.0.0.1
). See
Setting the IP Address with ScanTool
for details.
NOTE:
If you have your Security Internet Options set to
High
, you may not be able to access the Web interface
successfully; a high security setting disables JavaScript, which is required for running Proxim’s Web browser
interface. Adding the radio’s IP address as a Trusted site should fix this problem.
The Web Interface consists of Web page buttons and tabs. A tab can also contain sub-tabs. The following figure shows
the convention used to guide you to the correct tab or sub-tab.
The Web Interface also provides online help, which is stored on your computer (see
Step 15: Install Documentation and
for details).
2
3
1
Click Configure > Interfaces > Wireless:
