63
4.13.1.1 Results options
The “Results options” screen below is accessed via the context menu item ‘More...’
followed by the sub-menu item ‘Options’.
The ‘View options’ drop down menu provides the following options:
› ‘Actual’ – used to show just the measured alignment values without regard
to any target values or thermal growth values that have been entered, even if
they are active
› ‘Specification’ – shows just the effect of any target specifications and/or
thermal growth values that may have been entered and activated,
from a
baseline of zero
, without regard to any measured misalignment
› ‘Actual minus Specification’ – this option considers any specified coupling
targets or machine thermal growth, and is the default view. It is the option
that should be used when actually performing alignment corrections
If the option ‘Show correction arrows’ is activated, coloured tolerance arrows appear
at the feet positions as further help in determining the coupling alignment condition.
Note that these four
options are related to the
scaling of the machine
graphics. Only one of
the two options ( ‘Show
machine icons’ or ‘Show
reference line’) can be
selected at any one time.
When machine icons are
selected, the options
‘Show orientation text’
and ‘Show reference line’
are greyed out.
Tolerances’ envelopes can
be activated or deactivated
from the drop down menu
in this screen.
The colours of the arrows
are directly related to
the coupling alignment
condition as follows:
Blue – excellent [foot should
not be moved]
Green – good [if possible
foot should remain
unaltered]
Red – poor [foot requires
moving to attain a better
alignment condition]
Horizontal shaft alignment
Summary of Contents for ROTALIGN Ultra iS
