4.0
X/Z Axis Assembly Assembly - Reprap Prusa Mendel Build Manual
©2012 NextDayReprap
Prusa Mendel Kit Build Manual V1.01 - 07/2012
Step 4
Now take two 400mm smooth rods and push in to the horizontal holes on the X end idler. Then
slide two LM8UU Bearings onto the rod closest to the motor mounting point. Slide one LM8UU
Bearing on to the other smooth rod. Check the picture below to ensure your bearings are on
the correct rods.
Step 5
Slide the X Motor Mount onto the rods and then slide two 300mm smooth rods through the
LM8UU bearings in each X end part. It should now look like the photo below.