9.0
Wiring - Reprap Prusa Mendel Build Manual
©2012 NextDayReprap
Prusa Mendel Kit Build Manual V1.01 - 07/2012
Step 4
Crimp the larger of the prongs around the sheathed part of the wire. Ensure these grip the
sheathed wires, but do not crush the wire. Ensure your crimps are small and tight on the wire.
Ensure the connector is not bent. The whole of the metal connector will slide in to the plastic
PC Header connector so you should ensure there are no wires hanging and the metal crimp is
secure.
Step 5
Repeat the the process until all four wires from the stepper motor have connectors attached.