Manual for Prusa i3
www.makemendel.com
Page 2
Safety Instructions
1)
Use caution during assembly and operation of the 3D printer to ensure
no sharp edges will cut you.
2)
Always operate the printer a safe distance away from inflammable items.
Use in well-ventilated areas.
3)
Heatbed, Hotend and cartridge heater become hot during operation. DO
NOT touch hot surfaces, because they can cause severe burns. Allow the
hotend to cool before touching it without proper tools.
4)
DO NOT touch the chords of 3D printer if hands are wet.There are
chances of getting shock.
5)
Always use your 3D printer in a well-ventilated and clean area. Gas
emitted by melting of Polylactide (PLA) or Acrylonitrile butadiene styrene
(ABS) can contain contaminants that are harmful to breathe. Never
breathe the air that comes directly out of the hotend. This air is not
suitable for breathing.
6)
Electrical pins and sensors are delicate. Handle with care. Unless
instructed, DO NOT force components together. Read the instructions
carefully to prevent damaging parts during assembly or operation.
Summary of Contents for i3
