Building your MINI+
24
Original Prusa MINI+ semi-assembled
STEP 36
Adjusting the spool holder width
Place a spool of the filament you wish to you use in the spool holder. Align the
second base to match the size of the spool. We are using a spool of Prusament as an
example.
Once the holder is aligned, remove the spool, insert two M3x8 screws and tighten
them to prevent the parts from moving.
STEP 37
Attaching anti-slip pads
Grab the bundled anti-slip board and break out four pads.
Peel off the protective film and attach the pads from the bottom side of the spool
holder.
Tip: avoid attaching the pads near or on the rails, it might make future width
adjustments harder.
Summary of Contents for MINI+
