6. Spool holder assembly
Original Prusa MINI+ kit assembly
103
STEP 5
Adding the spool holder rails
Slide both rails in the first base assembly, use the grooves. Align the rail with the
edge of the base.
Secure the first base with two M3x8 screws. Use a reasonable force during the
tightening.
Slide the second base onto the rails. The exact position is not important at this
point - we will adjust it in the next step.
STEP 6
Adjusting the spool holder width
Place a spool of the filament you wish to you in the spool holder. Align the second
base to match the size of the spool. We are using a spool of Prusament as an
example.
Once the holder is aligned, remove the spool, insert two M3x8 screws and tighten
them to prevent the parts from moving.
Summary of Contents for Original Prusa MINI
