2. YZ - axis assembly
24
Original Prusa MINI+ kit assembly
STEP 19
Assembling the Y-carriage
NOW, PLEASE BE VERY
CAREFUL!
Gently insert the rod
straight into the bearings. Do not
apply too much force and do not tilt
the rod!
If you can't slide the smooth rod
easily, check to make sure that the
two bearings are aligned properly.
In case you manage to push out
balls from the bearings, please
count them. One or two balls are ok,
if there are more of them, please
consider ordering new bearings.
The bearings may leave excess
grease on the smooth rods after
their installation. Wipe off any
residue with a paper towel.
STEP 20
Mounting the Y-carriage
Place the Y-carriage on the extrusions. The side with
one bearing
must
face to the
left
.
Gently slide the smooth rods into the holes in the MINI-Y-front-plate. Start with the
left rod, then the right one.
Insert two M3nE into the side groove of the extrusion.
Insert one M3nE nut into the upper groove of the extrusion.
Before proceeding to the next step, make sure you have inserted all three M3nE
nuts.
Later insertion is difficult.
Don't forget to
wipe off the residue of the grease
on the smooth rods
with a paper
towel.
Summary of Contents for Original Prusa MINI
