2. YZ - axis assembly
32
Original Prusa MINI+ kit assembly
STEP 34
Assembling the MINI-Z-bottom
Insert two M3nS nuts from the top side of the MINI-z-bottom.
Turn the part upside down and insert two M3nS nuts.
Insert four M3n nuts. Make sure they are flush (aligned) with the surface of the
printed part.
Do not press too much on the bottom of the plastic part
, it may crack.
Glue the anti-vibration pad in the recess shape of the pad.
STEP 35
Buddy board: parts preparation
For the following steps, please prepare:
WARNING:
Make sure to
protect the electronics against electrostatic discharge
(ESD)
. Always unpack the electronics right before you need them!
Buddy board (1x) Keep the silver label for later!
Note that the anti-static bag will be opened upon arrival. Each board is taken
out and tested before shipping.
M3x8 screw (4x)
Summary of Contents for Original Prusa MINI
