3. X-axis & Extruder assembly
50
Original Prusa MINI+ kit assembly
STEP 5
X-end: parts preparation
For the following steps, please prepare:
MINI-X-end (1x)
M3nS nut (2x)
M3x12 screw (4x)
M3x20 screw (1x)
M3nN nyloc nut (1x)
Pulley Bearing Idler 623 2Z (1x)
The list continues in the next step.
STEP 6
X-end: parts preparation (lubricating)
For the following steps, please prepare:
Linear bearing LM8UU (2x) included in the
Rods package
Prusa lubricant aplicator (1x)
Prusa lubricant (1x)
Several paper towels to wipe oil and grease from the bearing surface.
Permanent marker (1x) not included in the kit
Each bearing must be lubricated before mounting on the printer.
Follow these
instructions carefully.
Summary of Contents for Original Prusa MINI
