3. X-axis & Extruder assembly
60
Original Prusa MINI+ kit assembly
STEP 25
Mounting the X-axis
Turn the assembly so that the rear side is facing you.
Place the X-axis on the Z-axis bearings and trapezoidal nut. Hold it by hand all the
time during installation.
Place the MINI-Z-carriage-rear on the bearings. See the round recess of the part for
better orientation.
Secure it with two M3x30 screws diagonally. You can release your hand from the
assembly now.
STEP 26
Mounting the X-axis
Insert and tighten two M3x30 screws into the remaining holes.
Look from below and align two holes in the trapezoidal nut against the holes in the
plastic parts.
Secure the trapezoidal nut to the X-axis with two M3x20 screws.
Summary of Contents for Original Prusa MINI
