4. Print head & Heatbed assembly
80
Original Prusa MINI+ kit assembly
STEP 14
Guiding the hotend cables
Start by rotating the lead screw with your fingers until the X-axis is in the highest
position. And move the print head all the way to the right and ensure it is touching
the printed part.
Bend the cable bundle slightly and guide it to the extruder.
Thread two zip ties through the holes in the extruder.
Place the cable bundle on the extruder as you see in the picture.
Secure the cable bundle by tightening both zip ties.
Insert the motor cable into the cable bundle.
Insert and tighten the third zip tie.
Cut the remaining part of each zip tie using pliers as closest to its head as possible.
STEP 15
Guiding the hotend cables
Rotate the zip tie's head to the left.
Make sure you have rotated the heads to the left
, otherwise you might have issues
during the print!
Slightly twist the sleeve (not the cables inside). The sleeve will evenly wrap all
around the cable bundle.
Summary of Contents for Original Prusa MINI
