5. LCD assembly & Electronics
Original Prusa MINI+ kit assembly
93
STEP 11
Filament sensor: parts preparation (optional)
For the following steps, please prepare:
M3x12 screw (4x)
Steel ball (1x)
M2x8 screw (1x)
Magnet 10x6x2 mm (2x)
Keep the magnets apart in a sufficient distance.
They can
break each other!
IR sensor cable (1x)
IR sensor (1x)
Textile sleeve 5x300 mm (1x)
STEP 12
Filament sensor assembling (optional)
Connect the IR sensor cable to the IR sensor.
See the clip on the connector and the notch on the sensor for better orientation.
Guide the cable under the IR sensor like in the picture.
Insert the IR sensor to the MINI-fsenzor-box.
Make sure the cable is still under the sensor.
Summary of Contents for Original Prusa MINI
