16
Remove the resin tank
1.
Remove the print platform
2.
Close the orange lid
3.
Confirm that you hear the music
4.
Wait until the check is finished
5.
Take a look at the display THROUGH the orange lid. Can you see the company logo on the
6.
exposure display? You can place a sheet of paper onto the screen to make the logo more
visible. Do not forget to close the cover!
Insert the tank and secure it with two tank screws
7.
Take the print platform and place it across the tank as seen in the picture. Close the cover and
8.
wait util the cantilever touches the print platform.
Finally, make sure the tank is correctly secured. Place the platform on the cantilever and
9.
secure it with the black knob. The printer will make the final check and the Selftest is finished.
Finally, there’s the
Calibration wizard.